Key Clamp Double Lugged Bracket for 33.7mm Tube, Panel Fixing, Galvanised, Size B

A galvanised bracket that clamps onto tube and gives a flat lug on each side, so a panel can be bolted across the tube or two panels joined on it. The round barrel slides over the tube and locks with one hex socket grub screw, so you can set it at any height and turn it to face any way. A flat plate runs across the barrel with a 10mm hole in each end, 88mm apart, and it sits almost flush with the face of the tube, so the panels lie close against the frame. It is malleable cast iron with a galvanised finish for indoor and outdoor use. The price shown is for one bracket, with a minimum order of 10.

Why fitters use it

Fix panels without drilling the tube. The bracket clamps on, so the tube stays whole and the bracket can be moved or added later.

Two fixing points in one fitting. Bolt one wide panel through both lugs for a firm hold, or butt two panels together on the tube with one lug each.

Panels sit tight to the frame. The plate lies almost in line with the face of the tube, so boards, mesh and signs fit close with no wide gap.

Galvanised for outdoors. The zinc coating protects the iron on yards, sites, ramps and walkways in all weathers.

Set at any height. Slide it along the tube, turn it to suit and lock it with the grub screw.

Where it is used

Mesh and sheet panels on guards and enclosures, sign boards between posts, plywood and sheet back panels on workshop frames, fence infill boards, and panels joined at a post on tube frames.

Specifications

How many do you need?

Choosing the right bracket

This bracket takes 33.7mm tube. Where a panel only needs fixing on one side, such as at the end of a run, use the single lugged bracket for 33.7mm tube. For 33.7mm tube there is a double lugged bracket and a single lugged bracket.

Building the frame? See the matching 90° elbow, oval base flange and end cap for 33.7mm tube.

Fitting and care

Slide the bracket onto the tube, turn the plate to face the panels and tighten the grub screw with a hex key. Hold the panel or panels in place, mark through the lug holes, drill and fix with an M8 or M10 bolt, washer and nut, or a screw to suit the board. Fit at least two brackets on each tube so the panels are held at top and bottom. Wipe clean with a damp cloth and touch up scratched galvanising with zinc-rich paint.

Frequently asked questions

Ordering and delivery

Order 10 or more online, with Express UK Delivery to your site and same-day dispatch on orders before 2pm, Monday to Friday. For a full fit-out or mixed fittings, call 01744 520 110 or email sales@industrialsuppliesco.co.uk and we will confirm availability and delivery before you order.