230V Roller Shutter Door Control Panel Kit with 2 Transmitters

A 230V control panel kit for one single phase roller shutter motor. If you are fitting a shutter on a unit, garage or warehouse and want proper control rather than a basic switch, this panel gives you up, stop and down at the lid, and from two 4-button transmitters. It has a photocell input and a safety edge input, each with self test, so the shutter is ready for a safe installation. A 24V output powers accessories, a 230V output runs a flashing light or courtesy light, and the programming is done with a button and a simple display. A plug-in adaptor takes the modular radio receiver, shown with the kit. Plug-in terminal boards make the wiring straightforward. The price shown is for the kit.

Why this panel works

Controls at the panel and at the transmitter. Up, down and stop are on the lid and also on the transmitter, along with control of the courtesy light. Two transmitters come in the kit so you can run the door from the vehicle or the workshop floor.

Safety inputs with self test. The photocell input and the safety edge input are each self testing, and the panel accepts mechanical, resistive or optical safety edges. There is a separate power adjustment output for an optical edge.

A fire alarm input. An emergency input lets you connect a fire alarm or alarm signal so that the panel can respond when the input is triggered.

Input status is shown on the display, which makes fault finding quicker when a safety device or wiring run is at fault.

Where it is used

Single phase roller shutters on commercial units, garages, warehouses, workshops and retail premises. It suits new installations and replacing an older control panel on a 230V motor. It is not for three phase shutter motors or motors at other voltages.

Specifications

Choosing the right control

Check your motor is 230V single phase before you order, and match it to the motor rating of your door. Maximum motor power is not published for this line, so if your shutter motor is large, call us with its data plate. For a swing or sliding gate rather than a shutter, use one of our gate control boxes instead, because a gate needs different logic and slow start settings.

Fitting and care

Isolate the supply before opening the panel. Fix it at the height recommended for your door, wire the motor to the motor terminals and connect the stop, photocell and safety edge inputs before programming. Do not bridge a safety input. Set the limits on the motor and run the door through a full cycle, checking the safety devices respond. Wiring should be done by a qualified electrician, and a powered door should be checked by a competent person.

Keep the lid closed and check the input status display at each service. Any change in the display on a door that has not been altered is a good sign of a wiring or sensor fault.

Frequently asked questions

Ordering and delivery

Order online, with Express UK Delivery to your site and same-day dispatch on orders before 2pm, Monday to Friday. For a larger job, call 01744 520 110 or email sales@industrialsuppliesco.co.uk and we will confirm availability and delivery before you order.