Key Clamp Long Tee for 33.7mm Tube, 90° Galvanised Rail Joint, Size B

The long tee carries a top rail over a post, and is the fitting to use where two lengths of rail meet. Its long barrel takes the rail straight through, or the ends of two rails pushed in from each side, and each is locked by its own grub screw; the post pushes up into the socket below with a third screw. It suits 33.7mm outside diameter tube, the usual size for light handrails and garden rails, and is malleable cast iron with a galvanised finish for indoor and outdoor use. The price shown is for one fitting, with a minimum order of 5.

Why use a long tee

Joins rail lengths over a post. Tube comes in fixed lengths, so any run of rail longer than one tube has joints. The long tee's barrel takes two rail ends, each with its own screw, so the joint sits over a post where it is fully supported and cannot sag.

Three screws, more grip. Two screws on the barrel and one on the post socket hold the rail and post firmly, even where the rail is a single length through.

No welding, no threading. Everything goes together with a hex key. Rails can be built on site, adjusted and taken down again.

Galvanised for outdoors. The zinc coating protects the iron in rain and frost, for steps, ramps, gardens and yards.

Where it is used

Handrails beside external steps and paths, decking and garden rails, light pedestrian barriers, school and play area rails, allotment and garden frames, and display frames made from 33.7mm tube.

Specifications

Long tee or short tee?

Use the long tee wherever two lengths of top rail meet over a post. Where the rail runs straight over a post in one length, the 33.7mm short tee does the job at lower cost. A short tee cannot join two rails inside it.

Which 33.7mm fitting goes where

How many do you need?

One long tee at every post where two top rail lengths meet. With 6 metre tube and posts at 1.5 or 2 metres, a joint falls on every third or fourth post.

Choosing the right size

Key clamps are sized by the tube's outside diameter. 33.7mm tube is often sold as 1" or 25mm nominal bore. Measure across the tube: this tee will not grip 32mm or 42.4mm tube. The same long tee in other sizes:

• 42.4mm long tee for standard handrails
• 48.3mm long tee for scaffold-size tube
• 26.9mm long tee for light frames
• Yellow 33.7mm long tee for safety rails indoors

Fitting and care

Push the post fully into the socket. Cut rail ends square and deburr them, then push each rail into the barrel so the two ends meet in the middle. Level the rail and tighten all three grub screws with a 1/4" hex key. Check the screws after the first week and once a year. Touch up scratched galvanising with zinc-rich paint. Spare screws: 33.7mm setscrews.

Frequently asked questions

Ordering and delivery

Order 5 or more online, with Express UK Delivery to your site and same-day dispatch on orders before 2pm, Monday to Friday. For a full rail kit, call 01744 520 110 or email sales@industrialsuppliesco.co.uk and we will confirm availability and delivery before you order.