Teak Composite Board Wax Repair Kit, 2 x 10cm Wax Sticks and Applicator

A teak wax repair kit for touching in chips, dents and small scratches on composite gate boards. A fence or gate gets knocked about by barrows, ladders and delivery trolleys, and a scratch on a capped board is noticeable. This kit holds two 10cm wax sticks in teak, with an applicator, so you can fill the mark and blend it in with the board around it. The sticks are a warm copper terracotta brown, chosen to go with our teak composite gate boards. The price shown is for one kit, with a minimum order of 5, so you can keep a spare on site for each colour.

Important: choose by board colour. This kit is teak. The board each kit goes with is linked in the table below.

Why this kit works

It is made for the small marks. The kit is intended for chips, dents and small scratches, the sort of minor surface damage that shows up on a gate in daily use. A wax stick fills the mark and leaves the surface level, rather than needing a board to be replaced.

The colour is teak. It is the colour of our teak board, which is a warm copper terracotta brown, so the wax sits close to the board around it. Match it against a clean, dry area of the board rather than a faded one.

Quick to use. The method printed on the pack is three steps: take off any raised edges with the applicator, rub the wax stick over the damaged area until it is level, then take off the excess wax with the applicator. There is nothing to mix and nothing to cure.

In short: it is for minor marks, in a colour matched to the board, with a three step method.

Where it is used

On teak composite gate boards and fence boards that have picked up chips, dents or small scratches: gates and fences at depots, schools, housing sites and commercial premises, and on handover snagging where a board has been marked during installation. It is for the surface of the board, so it is a touch-up for appearance.

Specifications

Choosing the right colour

Pick the colour of the board you are repairing. This kit is teak for our teak composite gate board. Hold a stick against a clean part of the board in daylight before you start, because boards weather and a board that has been outside for years can look a little different from a new one. The six board colours are linked here, so you can see which board each kit belongs with.

Fitting and care

Clean the board and let it dry. Use the applicator to take down any raised edge round the chip, then rub the wax stick over the damaged area in several directions until it is level with the board. Finish by taking off the excess wax with the applicator and buff lightly with a clean cloth if you wish. Test on a spare board or an out of sight area if the colour matters to you.

Keep the sticks in their pack in a cool, dry place, away from direct heat, and keep the kit with the site tools. Do not expect a wax to restore a board that is cracked or broken through, because the kit is only described for chips, dents and small scratches.

Frequently asked questions

Ordering and delivery

Order 5 or more online, with Express UK Delivery to your site and same-day dispatch on orders before 2pm, Monday to Friday. For a larger job, call 01744 520 110 or email sales@industrialsuppliesco.co.uk and we will confirm availability and delivery before you order.